The 3D printed flex gloves, by Revolution Sports
3D printed racing gloves made with flexible rubber material. The flex in our gloves is a real game changer! Flex allows feeling the pushrim easier through the fingers and thumb of the glove, and feeling power transfer through the palm of your hand. Starts are a breeze being able to squeeze your pushrims. Injury prevention is huge in wheelchair racing! The flex in our gloves absorbs the stress that is normally transferred to your wrist with other hard gloves.
Is pushing in the rain a stress for you? Not anymore! The flex and defined, yet forgiving groove in our glove grabs the pushrim and pushes well wet and dry. Gloves come as shown in main photo. Uncovered with a recess printed into the glove to receive rubber directly, or fabric AND foam.
- You are responsible for choosing your size! Please follow these instructions closely.
- We base our sizing off the 100% glove print. Those two measurements are: 21cm for the MCP joints and 11.5cm for the PIP joints.
NOTE: We are not all made the same! You can order different percentages for Right and Left… make sure you measure both hands!
1) MCP JOINTS (100/21)*(X)=???Example: If your measurement (X) is 19cm at the MCP joint, your calculation is: (100/21)*19= 90.476…
We will always recommend to round up to the closest whole percent, in this case 91%.
|2) PIP JOINTS (100/11.5)*(X)=???
Example: If your measurement (X) is 9.5cm at the PIP joint, your calculation is: (100/11.5)*9.5=82,6086..
We will always recommend to round up to the closest whole percent, in this case 83%.
Now that you have your two percentages, you need to pick the size for your glove. We would recommend choosing the higher percentage of the two measurements, but ultimately the decision is yours.
If you’re feeling unsure about any of these measurements or choices, please let us know! We are happy to help out..
No videos available
Fill out our form to get a verification of benefits within 24 hours - Insurance Verification Form .